Light Pole Base Installation

Simplified to Save You Time & Money on Your Light Pole Base Installation

LPB has revolutionized concrete light pole base installation by making it faster, easier, and more efficient. Unlike traditional precast light pole bases, which are often custom-made to order, LPBs are designed with universal features, allowing them to be kept in stock and ready for immediate delivery. This means contractors can get their product faster, speeding up construction timelines and reducing costs.

Compared to cast-in-place bases, which require more onsite labor, material delays, and ideal weather conditions, LPBs offer a streamlined alternative that saves time and effort. Want to see how simple it can be? Watch our Installation Video for a step-by-step overview. For more detailed guidance, our Installation Manual provides clear instructions to ensure a smooth installation process from start to finish or Contact Us with and questions.

Simplified to Save You Time & Money on Your Light Pole Base Installation

Installation Made Simple: Just Three Easy Steps!

augering a hole for light pole base installation

1. Auger

Determine the location for the LPB and auger or excavate hole at the marked location. Hole diameter should be 6 to 12-inches larger than the diameter of the LPB. Auger or excavate to the required embedment depth plus 6-inches. The additional depth will allow for installation of the base material. The required embedment depth will be specified by the design engineer and is based upon the actual site conditions. The bottom of the augered or excavated hole should be relatively flat.

setting base for light pole base installation

2. Place the LPB

Lower the LPB into hole. The base can be lifted by threading two straps through the center of the LPB or by attaching chains to the anchors located along the sides. Ensure that the conduit openings are aligned properly for the site and installation requirements. Once the LPB is in place, ensure that it is plumb, the top of the foundation is level, and the top surface elevation is set to the project requirements. Brace the LPB as required to maintain location and level until the unit can be backfilled.

backfilling and compacting for light pole base installation

3. Backfill

Place backfill material according to project requirements. Crushed stone or granular fill (sand) is recommended for all LPBs. Backfill should be applied uniformly in 6 to 8-inch lifts and compacted to 95% standard proctor density. Begin by backfilling to just below the large side openings, then install the required conduits through these openings and out the top of the LPB. Once conduit installation is complete, finish backfilling to the final grade elevation around the LPB perimeter.

Download the Full Installation Guide

The LPB Anchoring System

All-In-One Adjustable Anchoring for Light Pole Base Installation

The standout feature that sets the LPB light pole foundation apart is its innovative adjustable anchoring system. This unique design accommodates bolt circle diameters ranging from 7.5 inches to 13.5 inches, making it adaptable to a wide variety of light pole base installations. Each LPB foundation comes with a complete Installation Hardware Set, providing all the nuts, washers, and anchoring rods needed to set up the anchoring system and install the light pole. With LPB, there’s no need to source j-bolts separately—your light pole base producer supplies all the necessary hardware directly to you. Ready to simplify your next project? Visit our Where To Buy page to get LPB light pole bases today!

Looking for Technical Info?

Whether you need design details, specification, or to complete site specific calculations, we’ve got you covered.

Check out our Technical Resource Library or try BaseCalc LT to see if LPB is right for your project.